低压熔断器选型的研究与优化

doi:10.3969/j.issn.1008-0198.2022.06.020

湖南电力 ›› 2022, Vol. 42 ›› Issue (6): 114-118.doi: 10.3969/j.issn.1008-0198.2022.06.020

低压熔断器选型的研究与优化

徐铮, 姜培

扬子石化-巴斯夫有限责任公司,江苏南京 210048

收稿日期:2022-07-18 修回日期:2022-08-29 出版日期:2022-12-25 发布日期:2023-01-13

Research and Optimization of Low Voltage Fuse Type Selection

XU Zheng, JIANG Pei

BASF-YPC Company Limited,Nanjing 210048, China

Received:2022-07-18 Revised:2022-08-29 Online:2022-12-25 Published:2023-01-13

摘要/Abstract

摘要： 对高能效等级电机用熔断器的选择、熔断器开关的夹持力、水平安装方式下熔断器的降容及极限温升要求进行分析,提出低压熔断器新的选型方法,为低压熔断器的应用提供参考。

关键词: 低压熔断器, 温升, 夹持力, 安装方式

Abstract: This paper analyzes the selection of fuse for high energy efficiency grade motor, the clamping force of fuse switch, the requirements of capacity reduction and limit temperature rise of fuse under horizontal installation mode,proposes a new method for low-voltage fuse selection, and provides reference for the application of low-voltage fuses.

Key words: low-voltage fuses, temperature rise, withdrawal force, installation condition

中图分类号:

TM563
TM531

徐铮, 姜培. 低压熔断器选型的研究与优化[J]. 湖南电力, 2022, 42(6): 114-118.

XU Zheng, JIANG Pei. Research and Optimization of Low Voltage Fuse Type Selection[J]. Hunan Electric Power, 2022, 42(6): 114-118.

参考文献

[1]International electrotechnical commission. Low-voltage fuses-Part 1 General1requirements:IEC 60269-1-2014[S/OL].(2014-06-30)[2022-07-01].https://www.iec.ch/dyn/www/f?p=103:29:7737244116397::::FSP_ORG_ID,FSP_LANG_ID:1338,25.
[2]International electrotechnical commission. Low-voltage fuses-Part 5: Guidance for the application of low-voltage fuses: IEC 60269-5-2014[S/OL].(2014-06-30)[2022-07-01].https://www.iec.ch/dyn/www/f?p=103:23:7737244116397::::FSP_ORG_ID,FSP_LANG_ID:1338,25.
[3]焦夏男,王国庆,藏春艳,等. 一种中低压熔断器选型优化方法[J]. 电力电容器与无功补偿,2021,42(5):60-65.
[4]吕俊霞.低压熔断器的运行维护与故障诊断技术[J].灯与照明,2012,36(1):55-57.
[5]肖翼洋,庄劲武,陈搏.填砂密度对熔断器分断能力和电弧模型的影响[J].哈尔滨工程大学学报,2013,34(4):524-529.
[6]中国电器工业协会.高压交流负荷开关-熔断器组合电器:GB/T 16926—2009[S].北京:中国电力出版社,2009.
[7]陈博,庄劲武,肖翼洋,等.基于半经验模型的高压限流熔断器电弧特性的计算与分析[J].高电压技术,2014,40(1):282-287.
[8]刘志远,王彤,孙超,等.石英砂熔断器的弧前时间-电流特性[J].高电压技术,2018,44(2):366-371.
[9]王飞鸣,赵琦,赵义松,等.10 kV跌落式熔断器材质及温升试验分析研究[J].高压电器,2019,55(1):80-86.
[10]Szulborski Michał, Lapczyński Sebastian, Kolimas Lukasz, et al. Transient Thermal Analysis of NH000 gG 100A Fuse Link Employing Finite Element Method[J]. Energies, 2021,14(5):1-18.
[11]郭丽伟,薛永端,徐丙垠,等.中性点接地方式对供电可靠性的影响分析[J].电网技术,2015,39(8):2340-2345.
[12]Legeron F, Desjardins E, Ahmed E. Fuse performance on bracing of concentrically Steel braced frames under cyclic loading[J].Journal of Constructional Steel Research,2014,95:242-255.
[13]赵梦雅,梁制瑞.配电网 TV 高压熔断器熔断影响因素的分析[J]. 电测与仪表,2016,53(21):76-81
[14]张良,徐丙垠. 配电网分支线保护的配置与整定[J]. 电网技术,2016,40(5):1589-1594.
[15]万代,周卫华,齐飞,等.配电台区高低压设备典型故障分析[J].湖南电力,2021,40(1):95-97.
[16]周绍庚.火电厂TV熔断器熔断及开关爆炸事故分析[J].湖南电力,2013,33(4):36-37.

低压熔断器选型的研究与优化

Research and Optimization of Low Voltage Fuse Type Selection

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 0

编辑推荐

Metrics

本文评价