火电机组烟道积灰特性及防治方法的数值模拟研究

doi:10.3969/j.issn.1008-0198.2025.02.008

湖南电力 ›› 2025, Vol. 45 ›› Issue (2): 63-68.doi: 10.3969/j.issn.1008-0198.2025.02.008

• 源网协调与能源转换利用 • 上一篇下一篇

火电机组烟道积灰特性及防治方法的数值模拟研究

闫优洋, 陈冬林, 杨展, 王帅浩

长沙理工大学能源与动力工程学院,湖南长沙 410114

收稿日期:2024-11-07 修回日期:2024-12-11 发布日期:2025-04-30
通信作者: 陈冬林(1963),男,教授,博士生导师,从事锅炉及燃烧理论与技术研究应用、燃烧污染物减排技术等研究工作。
作者简介:闫优洋(2000),女,硕士,从事燃烧理论与高效清洁燃烧技术研究工作。杨展（2000）,男,硕士,从事燃烧理论与高效清洁燃烧技术研究工作。王帅浩（1998）,男,硕士,从事绿氨煤电耦合方法研究工作。

Numerical Simulation Study on Characteristics and Prevention Methods of Ash Deposition in Thermal Power Units Flue

YAN Youyang, CHEN Donglin, YANG Zhan, WANG Shuaihao

School of Energy and Power Engineering, Changsha University of Science and Technology, Changsha 410114, China

Received:2024-11-07 Revised:2024-12-11 Published:2025-04-30

摘要/Abstract

摘要： 针对火电机组深度调峰引发的烟道内积灰问题,通过构建烟道结构几何模型及内部流动的数学模型,基于Fluent的数值模拟方法,研究机组不同负荷工况下烟道内飞灰沉积特性及其颗粒分布特性,并基于工程实践经验提出烟道防积灰方法——烟道内加装导流板和高速射流喷管。模拟研究表明：当机组负荷低于80%时烟道内飞灰开始沉积,而当负荷低于40%时烟道内飞灰大量沉积;不同结构烟道的飞灰颗粒沉积量呈现出以下规律：T型烟道>直角弯头>水平烟道>渐变烟道,且所沉积的飞灰颗粒90%以上直径大于34 μm;与现有烟道相比,加装导流板或射流喷管后的烟道在机组低至40%负荷运行时飞灰沉积量可减少29.16%~58.62%。

关键词: 烟道, 积灰特性, 数值模拟, 积灰防治

Abstract: In order to solve the problem of ash deposition in the flue caused by deep peak loading regulation of thermal power units, based on the numerical simulation method of Fluent, the characteristics of fly ash deposition and particle distribution in the flue under different load conditions of thermal power units are studied by constructing a geometric model of the flue structure and a mathematical model of its internal flow. A method to prevent ash deposition in the flue is put forward based on the practical experience of engineering, which is to install a baffle and a high-speed jet nozzle in the flue. The simulation results show that fly ash begins to deposit in the flue when the load of the unit is lower than 80%, and a large number of fly ash deposits in the flue when the load is lower than 40%. The pattern of fly ash particle deposition in different flue structures is as follows: T-shaped flue>right-angle elbow>horizontal flue>gradual flue. And more than 90% of the deposited fly ash particles are larger than 34 μm in diameter. Compared with the existing flue, the flue equipped with the baffle or jet nozzle can reduce the fly ash deposition by 29.16%~58.62% when the unit is operating at 40% of the rated load.

Key words: flue, ash deposition characteristics, numerical simulation, ash deposition prevention

中图分类号:

TK227.3

闫优洋, 陈冬林, 杨展, 王帅浩. 火电机组烟道积灰特性及防治方法的数值模拟研究[J]. 湖南电力, 2025, 45(2): 63-68.

YAN Youyang, CHEN Donglin, YANG Zhan, WANG Shuaihao. Numerical Simulation Study on Characteristics and Prevention Methods of Ash Deposition in Thermal Power Units Flue[J]. Hunan Electric Power, 2025, 45(2): 63-68.

参考文献

[1] LIU S,SHEN J.Modeling of large-scale thermal power plants for performance prediction in deep peak shaving[J]. Energies,2022,15(9):3171.
[2] 于国强,刘克天,胡尊民,等. 大规模新能源并网下火电机组深度调峰优化调度[J].电力工程技术,2023,42(1):243-250.
[3] 周世豪,刘海玉,谢玉婷,等. 660 MW 循环流化床锅炉深度调峰背景下分离器入口烟道积灰模拟研究[J]. 热能动力工程,2024,39(7):115-122.
[4] 胡信韬,姜聪. 电站锅炉尾部烟道积灰的原因分析及处理[J]. 山东工业技术,2018(9):166-167.
[5] 李强. 深度调峰状态下锅炉尾部烟道积灰预测及防治[J]. 电站系统工程,2024,40(4):22-24.
[6] 陶林,杨秀军,张天武,等. 火电锅炉深度调峰技术浅析[J]. 锅炉制造,2023(5):7-8,23.
[7] FU S,CAO G,OU G F,et al.Numerical study of fly ash deposition process in low temperature economizer under SCR conditions[J]. Korean Journal of Chemical Engineering,2022,39(7):1717-1728.
[8] 熊锐,王焱敏,刘元德,等. 燃煤电厂低温省煤器烟道积灰改进办法初探[J]. 中国环保产业,2024(8):31-33.
[9] 陈鸿伟,赵宝宁,张千,等. 烟气飞灰对SCR脱硝催化剂的磨损性能试验研究[J]. 动力工程学报,2018,38(4):286-290.
[10] 黄磊. 低频大功率旋笛式可调频声波吹灰器在锅炉尾部受热面的运用[J]. 电力设备管理,2018(2):58-60.
[11] 李彦辉. 某超临界燃煤锅炉脱硝出口斜坡射流吹灰优化[J]. 价值工程,2024,43(25):71-73.
[12] 付双成,曹港,陈强飞,等. 低温省煤器飞灰沉积阻塞机理分析及结构优化[J]. 化工进展,2022,41(8):4035-4046.
[13] ZHU M X,LU H,ZHAO W J,et al.A numerical study of ash deposition characteristics in a 660MW supercritical tangential boiler[J]. Advanced Theory and Simulations,2023,6(11):2300133.
[14] 欧阳朔. 电站锅炉尾部烟道流场数值模拟分析及优化[D]. 北京:华北电力大学, 2021.
[15] 王福军. 计算流体动力学分析:CFD软件原理与应用[M]. 北京:清华大学出版社,2004.
[16] MIRANDA E P,SEMPÉRTEGUI-TAPIA D F,CHÁVEZ C A. Turbulence models performance to predict fluid mechanics and heat transfer characteristics of fluids flow in micro-scale channels[J]. Numerical Heat Transfer,Part A:Applications,2024:1-20.
[17] MA X Y,WANG D X,LIU B,et al.Numerical simulations and validation of gas-solid flows in a fluidized-bed roaster based on the CFD-DPM model[J]. The Canadian Journal of Chemical Engineering,2023,101(11):6577-6590.
[18] 王朝阳,陈鸿伟,程凯,等. 双变截面SCR脱硝系统速度场及浓度场优化研究[J]. 动力工程学报,2019,39(5):380-386.
[19] 董陈,乔海勇,牛国平,等. 某600 MW机组SCR烟气脱硝装置优化设计[J]. 热力发电,2014,43(12):99-104.
[20] 马国伟,刘成,王新良,等. 600 MW机组烟道系统数值模拟分析及改造[J]. 宁夏电力,2015(3):61-64.
[21] 孙倩倩,刘迎春,卿山,等. 600 MW机组煤粉混燃生物质气锅炉燃烧特性研究[J]. 热力发电,2021,50(5):75-80.
[22] STONE L,HASTIE D,ZIGAN S.Using a coupled CFD-DPM approach to predict particle settling in a horizontal air stream[J]. Advanced Powder Technology,2019,30(4):869-878.

火电机组烟道积灰特性及防治方法的数值模拟研究

Numerical Simulation Study on Characteristics and Prevention Methods of Ash Deposition in Thermal Power Units Flue

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 3

编辑推荐

Metrics

本文评价

[1]	覃跃, 李德波, 覃吴, 阚伟民, 余冯坚, 金凤雏. 600 MW超临界前后对冲锅炉燃烧特性数值模拟研究[J]. 湖南电力, 2024, 44(6): 46-54.
[2]	覃跃, 李德波, 覃吴, 郑浩奕, 余冯坚. 燃煤电厂锅炉水动力研究现状与展望[J]. 湖南电力, 2024, 44(5): 1-8.
[3]	叶茂菁, 吴天宇, 刘铠瑞, 王利民, 车得福. 超临界二氧化碳圆腔自然对流流动传热研究[J]. 湖南电力, 2023, 43(4): 1-8.