Hunan Electric Power ›› 2025, Vol. 45 ›› Issue (3): 84-88.doi: 10.3969/j.issn.1008-0198.2025.03.012

• Power Grid Operation and Control • Previous Articles     Next Articles

Research on Detection Method of Detection Sensors for 110 kV XLPE Cables

YU Ting1, DUAN Xiaoli1, LiU Sanwei1, ZHONG Lipeng2, Li Shaobin3, WANG Feng4   

  1. 1. State Grid Hunan Electric Power Company Limited Research institute, Changsha 410208, China;
    2. College of Electrical and information Engineering, Hunan University, Changsha 410082, China;
    3. Chang Lan Technology Group Co., Ltd., Changsha 410012, China;
    4. State Grid Hunan Electric Power Company Limited, Changsha 410004, China
  • Received:2025-03-17 Revised:2025-03-26 Published:2025-07-02

Abstract: Aiming at the poor detection effect of traditional partial discharge (hereinafter referred to as PD) of high-voltage XLPE (cross-linked polyethylene) cables, an innovative built-in partial discharge(PD) signal detection device for high-voltage cables is proposed. By improving the structure of cable terminals and intermediate joints, a flange interface is reserved into the tailpipe area of these components for embedding a PD detection antenna, enabling accurate and effective detection of PD signals while avoiding damage to the cable body. With the detection antenna adopting a double-helix structure, precise collection, transmission, analysis, and processing of PD signals ar achieved. Through simulation and testing, the central frequency of the built-in PD detection antenna for 110 kV XLPE high-voltage cables with lengths ranging from 50 to 500 meters is determined to be 20 MHz. Test results demonstrate that the built-in PD detection sensor can effectively detect PD signals.

Key words: XLPE cable, partial discharge detection, antenna, frequency

CLC Number: